SEAL U CUP CTC 1709860 FOR 3046 3054C 3054E 3056E 3066 3116 3126 3176 3306 ROS SEAL
1709860 SEAL-U-CUP parts 315C, 315D L, 318C, 318D L, 319C, 319D, 319D L, 319D LN, 320B, 320C, 320D, 320D FM, 320D FM RR, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 322C, 323D L, 323D LN, 323D SA, 323E L, 324D L, 325B L, 325C, ... SEAL
Compatible equipment models: 1709860:
EXCAVATOR 315C 315D L 318C 318D L 319C 319D 319D L 319D LN 320B 320C 320D 320D FM 320D FM RR 320E 320E L 320E LN 320E LRR 320E RR 322C 323D L 323D LN 323D SA 323E L 324D L 325B L 325C 325D 325D L 330B L 330C 330D L 345B II 345B L 345C L M325D MH
MOBILE HYD POWER UNIT 325D 329D L
WHEEL LOADER 950K 962K
WHEEL TRACTOR-SCRAPER 613G
WHEELED EXCAVATOR M316C M316D M318 M318C M318C MH M318D M318D MH M320 M322C M322D M322D MH M325C MH
Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00987512
Carefully install camshaft (4) in the cylinder block.
Illustration 2 g00987503
When installing the camshaft, make sure the number one cylinder is at top center of the compression stroke with the timing bolt installed in the flywheel. The camshaft timing is very important. The timing mark on the camshaft drive gear must line up with the timing mark on the idler gear. Refer to the Specifiions Manual for more information.
Ensure that the timing marks on the camshaft drive gear (1), the idler gear, and the crankshaft gear are aligned.
Lower the valve lifters onto the camshaft.
Install camshaft retainer plate (3) and bolts (2) on camshaft gear (1) .
Install the front cover.End By:
Install the unit injector hydraulic pump. Refer to Disassembly and Assembly, "Unit Injector Hydraulic Pump - Install".
Install the rocker arms and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
|
|
SEAL U CUP CTC 1709860 FOR 3046 3054C 3054E 3056E 3066 3116 3126 3176 3306 ROS SEAL Images
|
